Neon Flex Installation Guide for Architectural Projects

Neon Flex Installation Guide

Quick Answer: Install neon flex by respecting minimum bend radius, using approved adhesives for the substrate, sealing every cut and feed for IP67, mounting drivers in accessible locations, and commissioning with full-load night inspection of color uniformity.

Pre-Install Checks

- Verify BOM revision matches approved sample - Dry-fit bends on mock section - Confirm driver locations and cable routes

Bending & Routing

Do not exceed minimum radius — kinks create dark spots and open circuits. Use factory corner pieces or cut-and-join where drawings require tight geometry.

Mounting

Clean substrate; apply adhesive per manufacturer TDS and temperature window. Add mechanical clips on long vertical runs where specified.

Cutting & Sealing

1. De-energize circuit 2. Cut at marked point 3. Install end cap / heat-shrink / potting per IP kit 4. Test insulation before energizing

Commissioning

- Measure current per feed - Verify DMX scenes if applicable - Photograph night appearance for handover

Q: Can installers splice in the field? A: Yes with approved kits — unapproved splices void IP and warranty.

Q: When should samples be approved? A: Before bulk order — validate CCT, dimming, and installation in a mockup or sample room.

Conclusion

Installation quality defines outdoor life. Follow Mihoray termination instructions bundled with OEM shipments.

About Mihoray

Mihoray is a professional LED strip and neon flex manufacturer based in China, providing OEM and ODM lighting solutions for commercial, hospitality, architectural and landscape lighting projects worldwide.